Hello,
I am currently engaged in a project involving the S5D9 MCU family and am seeking documentation that delineates the process for utilizing UART or SWD to program and erase the flash memory.
Could you kindly point me towards the relevant documentation or resources that furnish a detailed guide on the Flash Serial Programming procedure for the S5D9 MCU family? Your guidance on this matter would be highly valued.
Thank you for your time and assistance.
Best regards, Mario
Hello dear Mario, thank you for posting to the Renesas community. S5D9 Supports programming through a dedicated boot loader by UART or USB. the boot mode will be selected through the 'MD' pin. and you can use the 'Renesas flash programmer tool' to program the flash memory. Besides that, you can utilize SWD or JTAG for both programming and debugging. Please check the below document and look for 'SCI Boot Mode' for more details.https://www.renesas.com/us/en/document/mah/s5d9-microcontroller-group-users-manual?r=1054626Also if you're new to the Synergy platform, the document below will guide you through the basics of Synergy.
https://www.renesas.com/us/en/document/gde/basics-renesas-synergy-platformI hope you find this information useful. Best regards,Hossein.
If this or any other user's response answers your concern, kindly verify the answer. Thank you!
Renesas Engineering Community Moderatorhttps://community.renesas.com/https://academy.renesas.com/en-support.renesas.com/.../