Hi Folks,

I'm a pretty new user so I have been working through tutorials and examples. However, I have run into a problem running the ZMOD4410_RA6M4_NonOS demo code. I can't seem to get any data through to the expressions window in e2 studio after rechecking my steps, multiple times, following the documentation.

I have already run up the similar HS400x_RA6M4_NonOS without any difficulty, so I know that I2C is working OK. My gut is telling me that there may be an I2C address mismatch in the code for the sensor (which would be unfortunate for a demo) but I was wondering if anyone familiar with this example had any suggestions of where this may be going wrong?