supplying power using E2-Lite

Hi Captain,

I can't confirm if there are other ways for E2 Lite to supply power to the target when not debugging. The same in RFP, target supply is switched off once programming is done. I guess you should use a separate power supply for the target. The E2 Lite also can only supply 3.3V up to 200mA so it would be better to use a separate power supply.

JB
If this response, or one provided by another user, answers your question, please verify the answer. Thank you!
Renesas Engineering Community Moderator
https://community.renesas.com/
https://academy.renesas.com/
https://en-support.renesas.com/knowledgeBase/

Hi Captain,

I can't confirm if there are other ways for E2 Lite to supply power to the target when not debugging. The same in RFP, target supply is switched off once programming is done. I guess you should use a separate power supply for the target. The E2 Lite also can only supply 3.3V up to 200mA so it would be better to use a separate power supply.

JB
If this response, or one provided by another user, answers your question, please verify the answer. Thank you!
Renesas Engineering Community Moderator
https://community.renesas.com/
https://academy.renesas.com/
https://en-support.renesas.com/knowledgeBase/

Thanks for the response.