i am working on the Renesas RX63N MCU,
i am getting the dialouge box of "ID code verification" while connecting through the E1 debugger.. but i have not set any password for flash in my code.
pls provide the solution for this asap and also the cause.
thank u. :)
Is this your own board or a demo kit, are you using the E1. The I/Os on the E1 have to be in the correct polarity to enable programming otherwise you just get the baud rate switching that you reffered to.
yes i am using own board and i am using E1 debugger..
for boot mode i connected MD pin to the gnd...
is this right method????
New Microsoft Word Document.docx
What settings are you using on the E1. For the Pin Outputs we use 0x36 and the Pin Settings (High) as 0 so all outputs low.
what do u mean by pin output setting(high) 0x36 ???
When you connect the e1 in generic boot mode using FDT you should be presented with a window to select which pins are used as output and which of these are set high. Do you get this option?
If you do then set the Pin Output row such that the end result give 0x36. This should be io1 to io4. Then we don't set any high so the Pin Setting(High) row should be 0. These could be different depending on your hardware.