I need E2 lite pinout diagram

Exactly which MCU is in your controller?  The E2-Lite on-chip debugger supports only Renesas MCUs, and only certain debug interfaces depending on the device (e.g. on ARM devices the E2-Lite only supports SWD, not JTAG).  The device support list and the debug interfaces supported can be found in the document:

On-chip Debuggers Performance Property

Exactly which MCU is in your controller?  The E2-Lite on-chip debugger supports only Renesas MCUs, and only certain debug interfaces depending on the device (e.g. on ARM devices the E2-Lite only supports SWD, not JTAG).  The device support list and the debug interfaces supported can be found in the document:

On-chip Debuggers Performance Property

Hi,

I’ve attached my MCU schematic and the E2 pin configuration below. I’m trying to connect the debugger directly to my board, but I'm getting an error, which I have also attached. Could you please let me know where I might have made a mistake?

Regards,

Ashok

Hi JimB,

I got that but i'm trucking one point in clock, I have uploaded the screenshot and can you please suggest me the debug configuration please.

Please suggest me it very helpful for me.

Regards,

Ashok  

I don't understand what it is that you are asking for - it appears that you were able to establish a connection and set a breakpoint. 

Hello ashok,

From the debug window, it seems that your code stuck in while loop, which is used for stabilization of main clock oscillator.

Also, I can use that you try to debug on your own board, so what crystal capacitances and what reference designs did you follow to design the mcu clocks on the board?

Regards