Hello,
I am using Renesas E1 Emulator with e2 Studio on RL78 D1A series R5F10CME 80 Pin MCU with out CAN. I am able to compile the source code written in C language able to run the code in debug mode, able to set the break points. I am not able to view live tracking of variables in the debug mode.
Please let me know, how to view variables during debug mode. Please let me know how to program the R5F10CME MCU using E1 Emulator and e2 Studio. Please share the details on how to program the output hex file.
To enable real time refresh of variables please refer to this article.
https://en-support.renesas.com/knowledgeBase/21056458
The Pseudo-RRM/DMM function setting on Code Generator is this:
To program a program file on the device you can use Renesas Flash Programmer:
https://www.renesas.com/en/software-tool/renesas-flash-programmer-programming-gui
You can select the type of the output file with this project setting: