RL78/G1D how to configure transmitting power level and battery level in Simple Sample program

Hi,

I.m working on RL78/G1D SIMPLE SAMPLE PROGRAM embedded config-CCRL. how to configure different transmitting power levels and battery levels . I enabled the transmitting power services and battery services, defining it by macro definition and also defining in prfsel.c file. I want to choose different tx power levels in client side(ble scanner-app). Please give me a solution for my issue.

thank you,

0 JB (SWF) over 6 years ago

Hi Dinesh,

I'm not sure if there's any documentation for this. Have you check the application note for the sample program?

JB
RenesasRulz Forum Moderator

https://renesasrulz.com/
https://academy.renesas.com/
https://en-us.knowledgebase.renesas.com/
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 dinesh over 6 years ago in reply to JB (SWF)

Hi Sir,

There is No application note for the sample program about Tx power and battery services . I need it because this are mandatory things. Please guide me, how to build it in embedded configuration of rl78/g1d. i stuck up in this issue long time before, so please help me out. Thank you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Mike Clements over 5 years ago in reply to dinesh

dinesh,

Have you experienced success with your project?
Have you found the answers you were looking for?

Mike Clements
RenesasRulz Moderator
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 FrancisReeves over 4 years ago

mcdvoice

I got sufficient information from your soul of heart.Thank you so much. Awesome content
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel